Tag Archives: radio

Speaker Vibration

Vibrating ScreenVibrating ScreenEver since I got the radio installed in the Beetle, there was this vibration coming from the speaker grill any time the volume was turned up. Took out the grill today and determined that the vibration sound was the wire mesh that sits between the speaker grill and the speaker. At some point in Mabel’s life, some body had installed a piece of vinyl between the speaker grill and the opening for the speaker to keep air from coming through, so I removed that and secured the wire mesh with double sided tape…no more vibration and with the vinyl removed, it sounds so much better.

Vintage Radio Install Part II

Vintage Radio InstallationVintage Radio InstallationVintage Radio InstallationFinished installing the vintage radio into the Beetle this evening. Had to remove the air intake to install the back support for the radio. Installed the speaker and buttoned everything up. Very pleased with the end result, wouldn’t hesitate to do it again.

Vintage Radio Installation

Vintage Radio Install Part I

1968 VW Beetle Vintage Radio Install1968 VW Beetle Vintage Radio Install1968 VW Beetle Vintage Radio Install1968 VW Beetle Vintage Radio InstallI’ve been wanting to install a vintage radio in the Beetle for some time now and last week I came across a great deal on a new old stock Tenna Ranger that is period correct. So I received the radio in the mail the other day and was excited to open the box that had been sealed for over 47 years. This is the same radio kit that the dealers would’ve installed at the dealership after you purchased your new Beetle. My next hope was that the radio would actually work after being tucked away that long. Regardless of whether it worked or not, it was going to get installed. So last night, I began the install process. The hardest part so far was removing the dash pad material that would open the hole for the radio. This stuff is extremely tough. But after an hour or so of chipping away at it, the opening was clear and ready for the install. The radio slid right in and locked into place. Next, it was a matter of feeding the wires through the back and connecting the antenna. At this point, it was time to test the radio. Hot wire was connected to the fuse bus, ground wire was secured, wire for the radio light was piggybacked off of the speedo light and the speaker was temporarily connected. To my amazement, the radio fired up, all of the controls and the light worked and even the speaker worked. I was very, very pleased. I quickly tuned in an AM station and listened to the sounds of the 60’s and 70’s. Next, I’ll install the rear support for the radio (air intake will have to come out temporarily to gain access), install the speaker and button up the wiring. Hope to get it finished up tomorrow night.

1968 VW Beetle Vintage Radio Install

Vintage Radio Install

I’ll be installing a vintage Tenna Ranger radio hopefully this weekend, depending on the weather. I know a lot of others are planning on doing a similar project with their VW, so I’ve posted instructions for installing a vintage radio. Just click on the link to the right: Tenna-VW

Next Project

Tenna RangerTenna RangerEven though I use my phone and blue tooth speaker for tunes when I’m driving Mabel around town, I really wanted a period correct radio to fill in the dash. After months and months of searching, I came across a vintage NOS Tenna Ranger AM radio for Volkswagen. Sold as an aftermarket accessory for use exclusively in VW, complete kit includes radio, faceplate, mounting accessories, etc. Radio can be used in either 6 volt systems or 12 volt systems, voltage can be set on the back. Popular accessory sold years ago to install a radio in a VW in models that were not factory equipped with one, or as a replacement for the original radio. So, even though it’s not a factory radio, I only paid 50 dollars for a working, NOS radio that looks just like the factory radio and it’s period correct. Not to bad.